This guide will demonstrate how to create a Native ads campaign in a few simple steps.

To get started, click "Create a new campaign" –> "Express campaign":

...or click here for a direct link.

Next, select "Native" as an ad format:

Please note that the campaign can contain up to 20 creatives.

After that, fill in the basic campaign details:

You can add macros to the URL. Select the device type that you are targeting (for additional options, switch to "Advanced selection").

To target specific countries/regions/cities (i.e. geos), choose the “Custom” option and insert the custom information:

Time to add the creative:

Click "Browse" to upload an image. Follow the link to check guidelines for images and Native ads in general.

Do not forget to fill in the "Title" and "Brand" fields. Here are some useful tips on writing catchy titles for Native ads.

Now, select your preferred targeting options:

For the supply source - you can choose between direct Adcash traffic or partner traffic.

For zones - if you use [zone] macros in the “landing page URL” then Adcash will send you a Zone ID that you can use to blacklist certain traffic from your campaign.

The ad schedule allows to set up a time and dates when the campaign should run.

Now, select the bid type and amount:

Choose a suitable payout type from CPC, CPM. Based on the geos and formats you have chosen, the system will suggest a bid to get sufficient traffic. Please pay attention to the bid notification (in red) which shows the lowest possible bid.

Next, select a budget for the campaign:

"Daily budget" limits the campaign's daily spending to a specified amount. "Spread budget" option equally distributes the traffic over 24h. If the box is left unticked, then the traffic will be sent without limitations and thus, the daily budget limit most likely will be reached too quickly.

"Limit campaign period" automatically starts and pauses the campaign according to the setup and chosen dates.

"Custom" option allows to set up a total campaign budget (which can be increased on an as-needed basis).

Once your campaign is ready, click "Submit campaign".

Then your campaign will go through a validation process, that can take mere minutes during the working hours. After validation, the campaign will be either run or paused, depending on the following settings inside the campaign:

Please note that you can activate your campaign at any time.